Vitek VTC-IR302FN Especificações descarregar pdf (Página 21)

ENVI Series: VTC-IR302FN

should be created on the desktop of your computer. You can start IP Installer by double clicking

the icon.

Or you can also start the program by clicking Start > All Programs > IP Installer > IP

Installer as shown below.

After the program has started, the main window of IP Installer program will appear on the

screen as shown below. There are no network devices shown, as it is the first time running the

program and nothing has been registered.

Search Product

Scan the network and shows the list of all the Vitek products that IP

Installer program found.

Clear Product List

Clear the Vitek products list created by searching the network.

Automatic IP Setup

Configure the network setting of selected IP device in Automatic mode.

Manual IP Setup

Configure the network setting of selected IP device in Manual mode.

Connect Product

Homepage

Connect to the server homepage of the selected IP device.

Update Firmware

Update the firmware of the selected IP device.

Filter Configuration

Define the range of MAC and IP addresses to search.

9.2. Search Product

Make sure that your Vitek products are powered and connected to the network, and then

click the Search Product button. A status window will pop up to show the progress of

the search. Wait until it reaches 100%, or you may press the Cancel button to stop the

search at any given time and proceed with the results made until that moment.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 192 193

Sem comentários

Vitek VTC-IR302FN Especificações Página 21